Knob and Tube Wiring | What Older Homes Need to Know 2026
Home / Blog / Knob and Tube Wiring
Safety Guide

Knob and Tube Wiring: What Older Homes Need to Know

Quick Answer

Knob and tube wiring, found in some Australian homes built before the 1960s, has no earth wire and predates safety switch technology entirely. It isn't automatically dangerous if intact and undisturbed, but it can't support modern safety switch protection without rewiring, and insurers and buyers increasingly treat it as a risk factor.

What Is Knob and Tube Wiring?

Knob and tube wiring is an early electrical wiring method using porcelain knobs to support conductors running through roof and wall spaces, and porcelain tubes where wires pass through timber framing. It was common in Australian homes built roughly up to the 1950s, before modern sheathed cabling and earthing became standard practice.

Why It Doesn't Support Modern Safety Switches

Knob and tube wiring has no earth conductor, the dedicated path that gives fault current somewhere safe to go, which modern RCD (safety switch) protection relies on to detect faults correctly. Without that earth path, a safety switch can't be relied upon to work the way it's designed to on knob and tube circuits, which is one of the main reasons this wiring type is treated as a safety concern today.

Signs Your Home Might Have Knob and Tube Wiring

  • The home's age — built in the Federation, early Californian bungalow era, or earlier.
  • Visible porcelain fittings in an accessible roof space, small ceramic knobs and tubes supporting the wiring.
  • No earth pin on older power points, or power points that look original to the home.
  • No safety switches on the switchboard, often alongside other signs of original, unupdated wiring.

Full Rewire vs Partial Upgrade: What's the Right Approach?

Because knob and tube wiring lacks earthing throughout, a partial upgrade (replacing just some circuits) still leaves the rest of the home without proper earth protection. A full rewire is the usual recommendation where knob and tube wiring is present and the home is being brought up to modern safety standards, rather than attempting to patch sections of it.

What It Costs to Replace

Replacing knob and tube wiring is priced similarly to a full house rewire, since it involves the same scope of work, running new cable throughout the home and fitting a modern, properly earthed switchboard. The exact cost depends on the home's size, number of circuits, and wall and ceiling access, covered in more detail in our general house rewiring cost guide.

Key Takeaways

  • Knob and tube wiring predates the 1960s and has no earth wire, unlike modern cabling.
  • It can't properly support RCD (safety switch) protection without being replaced.
  • Common in homes from the Federation and early Californian bungalow era, still found in parts of older Sydney suburbs.
  • Insurers and buyers increasingly treat knob and tube wiring as a red flag, even when it's still technically functioning.
  • Replacing it is usually a full rewire, priced similarly to other whole-house rewiring work.
Common questions

Frequently Asked Questions

It isn't automatically illegal if existing and undisturbed, but it can't be extended or added to under current wiring standards, and most insurers and lenders treat it as a significant risk factor worth addressing.

Not properly. Knob and tube wiring lacks the earth connection that safety switches rely on to function correctly, so a licensed electrician needs to assess your specific situation before recommending a path forward.

The clearest sign is the home's age, built before the 1960s, combined with visible porcelain knob and tube fittings in an accessible roof space. A licensed electrician can confirm it with an inspection.

Need an electrician? Call now.

Licensed, insured, on-site fast. Available 24/7.

1300 415 254