Why Some Older Homes Have Aluminium Wiring
Through parts of the 1960s and 70s, copper price spikes led some builders in Australia to use aluminium wiring in place of copper for parts of a home's electrical circuits, it was cheaper and still conducted electricity well enough to meet the standards of the time. It's far less common than copper overall, but it does turn up in homes of that era, particularly in some larger circuits like stoves and hot water systems.
The Real Risk, and What It Isn't
Aluminium wiring itself isn't inherently dangerous sitting inside a wall doing nothing. The real risk sits at connection points, aluminium expands and contracts with heat more than copper, which over decades can loosen the connection at switches, outlets and the switchboard itself. A loose connection under load generates heat, and heat at a connection point is how electrical fires start. It's an ageing and connection issue more than a wiring-itself issue.
Signs Your Home Might Have Aluminium Wiring
- Age of the home — built or last fully rewired in the 1960s or 70s is the biggest single indicator.
- Markings at the switchboard — aluminium cable is sometimes marked "AL" or "ALUM" on its outer sheath where it's visible.
- Warm power points or switch plates — a sign of heat building up at a loose connection, worth having checked immediately.
- Flickering lights with no obvious appliance cause — can point to a loosening connection further back in the circuit, related to what we cover in our guide on why lights flicker.
What to Do If You Have It
A licensed electrician can inspect your switchboard and accessible connection points to assess the actual condition, not just confirm the wiring exists. Depending on what's found, the fix ranges from pigtailing (joining a short length of copper to the aluminium at each connection point with an approved connector, addressing the main risk area without a full rewire) through to a full rewire if the wiring and insulation are genuinely degraded throughout.
What Pushes the Cost Up
A full rewire costs significantly more than pigtailing, and the right approach depends on the actual condition found on inspection, not the age of the home alone. Wall and ceiling access, the number of circuits involved, and whether plaster or cladding needs to be opened and repaired all affect the final cost of either approach.