Why Split Systems Need Their Own Circuit
A split system air conditioner draws a sustained electrical load that's too much for a shared general power circuit, particularly during compressor start-up when the current draw briefly spikes. Under the wiring rules, split systems need a dedicated circuit sized to the unit, run back to its own breaker on the switchboard, not plugged into or wired alongside existing power points.
What the Electrical Work Actually Involves
- A dedicated circuit and breaker — sized correctly for the specific unit's rated current, not a generic size.
- A weatherproof isolator switch — installed near the outdoor unit so it can be safely isolated for servicing, this is a mandatory safety requirement, not optional.
- Correct cable sizing — based on the unit's amperage and the length of the cable run from the switchboard.
- Switchboard capacity check — confirming your existing board has room for another circuit breaker before the installer arrives to fit the unit.
Switchboard Capacity Checks
Older switchboards, particularly ones without spare breaker space, sometimes need an upgrade before a new air conditioning circuit can be added. This is worth checking before you book an installation date for the unit itself, so you're not caught out partway through the job.
What Pushes the Price Up
Longer cable runs between the switchboard and the outdoor unit's location add cost, as does a switchboard that needs upgrading first to make room. Multi-head systems, where one outdoor unit feeds several indoor heads, or installing multiple separate split systems in one visit, both add to the electrical scope beyond a single unit.
Coordinating With Your Air Conditioning Installer
Your air conditioning installer typically handles mounting the indoor and outdoor units and the refrigerant piping and gas work between them. The dedicated electrical circuit, isolator switch and switchboard connection is licensed electrical work and is usually either subcontracted to or coordinated with a separate electrician, worth confirming which before the job starts so nothing falls between the two trades.